Line level is a term used to denote the strength of an audio signal used to transmit analog sound information between audio components such as CD and DVD players, TVs, audio amplifiers, and mixing consoles, and sometimes MP3 players.

In contrast to line level, there are weaker audio signals, such as those from microphones and instrument pickups, and stronger signals, such as those used to drive headphones and loudspeakers. The strength of the various signals does not necessarily correlate with the output voltage of a device; it also depends on the source's output impedance, or the amount of current available to drive different loads.

Nominal levels

A line level describes a line's nominal signal level as a ratio, expressed in decibels, against a standard reference voltage. The nominal level and the reference voltage against which it is expressed depend on the line level being used. While the nominal levels themselves vary, only two reference voltages are common: Decibel volts (dBV) for consumer applications, and decibels unloaded (dBu) for professional applications.

The reference voltage for the decibel volt (0 dBV) is 1 V_RMS, which is the voltage required to produce 1 milliwatt (mW) of power across a 1 kilohm (kΩ) load^[1]. The reference voltage for the decibel unloaded (0 dBu) is the voltage required to produce 1 mW of power across a 600 Ω load (approximately 0.7746 V_RMS).

The most common nominal level for consumer audio equipment is −10 dBV, and the most common nominal level for professional equipment is 4 dBu. By convention, nominal levels are always written with an explicit sign symbol. Thus 4 dBu is written as +4 dBu.

Expressed in absolute terms, a signal at −10 dBV is equivalent to a sine wave signal with an amplitude of approximately 0.1414 volts, or any general signal at 0.1 volts root mean square (V_RMS). A signal at +4 dBu is equivalent to a sine wave signal with an amplitude of approximately 1.736 volts, or any general signal at approximately 1.228 V_RMS.

Line level in traditional signal paths

Acoustic sounds (such as voices or a musical instruments) are often recorded with transducers (microphones and pickups) that produce weak electrical signals. These signals must be amplified to line level, where they are more easily manipulated by other devices such as mixing consoles and tape recorders. Such amplification is performed by a device known as a preamplifier or "preamp". After manipulation at line level, signals are then typically sent to a device known as a power amplifier, where they are amplified to levels that can drive headphones or loudspeakers, which convert the signals back into sounds that can be heard through the air.

Most phonographs also have a low output level and require a preamp; typically, a home stereo amplifier will have a special phono input with a built-in preamp, which is much more sensitive than a standard, line-level input. The built-in phono preamp also accounts for the RIAA equalization curve resident to phonograph recordings.

See also

• Nominal level
• Alignment level

References

Bibliography

1. (1998) in Glenn M. Ballou: Handbook for Sound Engineers: The New Audio Cyclopedia, Second Edition. Focal Press. ISBN 0-240-80331-0. .

External links

• Conversion of dBu to volts, dBV to volts, and volts to dBu, and dBV
• Conversion of voltage V to dB, dBu, dBV, and dBm
• Units dBV in consumer equipment, dBu in professional equipment
• The Decibel